送彩金的棋牌网站大白菜

Welcome to the official website of Dongguan Dongli Electromechanical Co., Ltd. ! Service Hotline: 0769-85153718
Your location: 送彩金的棋牌网站大白菜- > Common problems- > Analysis of the problem of the hard tooth surface reducer cannot start

Analysis of the problem that the hard tooth surface reducer cannot start


、测试开关电源开关电源及连接线难题。 1 , test switching power supply switching power supply and connection problems.

、测试减速器轴,查询是不是出現漆料裂开出現小疹子。 2. Test the shaft of the reducer and check whether there is a small rash in the paint cracking.

、测试电机。 3. Test the motor.

During the entire operation of the hard toothed surface reducer, there will be a variety of different problems. People should quickly deal with such problems according to the situation on the spot. This requires certain professional skills. Follow Shenzhen to reduce speed together. The technical personnel of the gear manufacturer looked at the hard toothed surface reducer to start the problem and do a test analysis. Allow everyone to quickly identify common faults in the operation of hard tooth surface reducer. Analyze why the hard tooth surface reducer cannot start


When you turn on the main power switch one day, you find that the hard-toothed gear reducer cannot be operated. Don't rush to complain that the quality of the reducer is not good. Disconnect the power switch first, and check whether the power switch is normal. The nominal nameplate of the gear reducer is often marked with the rated current of the equipment. At that time, it is determined whether the working voltage is tested properly. If everything is normal, check the overall target equipment, that is, the equipment connected to the load rate shaft. You can try to drive the shaft to see if everything can rotate normally. If you can't rotate, try to extract the hard toothed surface reducer and try again. Then you can distinguish the problem of the reducer or the common failure of the overall target equipment. During the entire inspection process, you should pay attention to query whether the drive shaft is abnormal, and see if there is a small rash that will endanger the work of the drive shaft. This is because the paint layer is cracked and some locations are damaged by the cold and cold. The conductor and insulator resistors are reduced after secondary air-drying, and then there will be a pasty smell of the reducer. In this situation, you must use an iron shovel to remove unnecessary paint layers on the drive shaft, and clean and neat Then eliminate these small rashes. Although the actual operation of these versions is simple, if you don't pay attention to it, new problems will appear.

Checking out after various methods is a difficult problem for electric motors. This also requires professional and technical personnel to test and repair. When the warranty period can be contacted after-sales service. The problem of the testing instrument is usually the most easily overlooked problem. It will be a power plug that is not connected or disconnected. When testing the hard toothed reducer, the process must be sequenced. No reason. Disassemble the machine, first look at the very simple reasons that will cause common failures. Which of the disassemble machines is best left.

送彩金的棋牌网站大白菜 | Gear reducer | Worm reducer | Product customization | Common problem | Application case | Enterprise strength | Information center | 送彩金的棋牌网站大白菜 | Contact us
Dongguan Dongli Electromechanical Co., Ltd. All rights reserved @ Copyright Technical support: Dongguan website construction [ BMAP ] [ GMAP ]
Service Hotline: 0769-85153718 Guangdong ICP No. 11027165 Fax: 0769-85701760 [ Baidu Statistics ]
* The relevant webpage materials and related resources on this site are from the Internet. Please inform us if there is any infringement. We will delete them within 24 hours. [ Background Management ]
  • Back to top
  • 13924376581
  • 15078902059
  • Scan to add WeChat
  • Download Mobile APP