In the process of using transmission machinery, it may be the design process or the replacement process. Regardless of the purpose for which the reducer or the motor is required, it is necessary to know the dimensions of some components connected to the reducer and the motor. ? 需要注意什么呢 ? So what are these parts and what do you need to pay attention to ?
: 直联式以及分体式。 There are two types of reducer and motor connection : direct connection and split type.
: 直联形式的减速机与电机在组合入下图。 Direct-connection type : The combination of the reducer and motor in the direct-connection form is shown in the figure below. In their backbone structure, they do not want the split type reducer to have flanges or couplings or other forms of connection. If it is a directly connected reducer or the motor is broken during use, then the phone that needs to be replaced is not so simple. Because the size of the connection position of the direct-connected reducer motor made by each manufacturer is different, if it is not the original brand, it may not be installed. At this time, it is necessary to check the size of the connecting part and whether there is any difference between the size of the screw hole and the shaft.
: 分体式减速机与直连式减速机在连接方式上会有比较明显的区别，看下图。 Split type : There is a clear difference in the connection method between the split type reducer and the directly connected reducer. See the figure below.
There are more connected modules. This is the connection between the reducer and the motor. At this time, you need to know the size of the output flange of the motor. Is it a square servo motor flange or a general circular motor flange? The size of the shaft hole and the screw hole or the size of the step should be checked. If you have any questions, you can leave a message to the editor. If the editor cannot solve the problem, I will ask the technology to help you solve it.